Easy Assembly

Maxfun electric scooter are shipped 95% assembled.
It takes a few easy steps to complete the assembly and around 15 minutes to complete.

Unfolding

  1. The first step is to unfold your electric scooter. To do this, make sure the hooks are not caught on the rear foot – board. If it is, push the rod down and remove it from the rear footboard.
  2. Unfold the steering bar by pulling it to a vertical position. Ensure you do so until the Steering Bar is completely verti – cal.
  3. Make sure the steering bar is secured by turning the safety lock to the right until it is tight.
  4. Lastly, make sure the safety button of the folding mechanism is clipped to the steering bar. This safety mechanism prevents the latch from unlocking due to vibration or shock.

Install handlebars

  1. The first step is to remove 4 screws in order to install the handlebar of the electric scooter.
  2. Put on the handle of the electric scooter, then align the mounting module with the four screw holes, and press the module.
  3. Press and hold the installation module, and screw the four screw holes to the right respectively, don’t tighten it, just hang it.
  4. Finally, tighten the screws on the four screw holes to the right to ensure that the handle is installed securely.